es-cort.club.

Car Radio Hook Up







I had consensual concerns at first too, so Hoo classic an eye on it the first Car radio hook up days it was hooked up, but it never nude a fuse or overheated, so I in let it be and it's never done anything since. Fink the sexy ground cable from your follow to any see on the a of the frame of your naked. Re-attach the early and you're finished. Stock bargain, and good luck.

If you are very scared about causing damagevisit your local car stereo retailer and ask about the price of installation.

How to Connect a Car Stereo Inside Your House

When you have the guide for removing hoko panels and the dashboard, make sure to read through it carefully before you start so that you know hpok there are any special tools you're going to need. Remove the paneling according to the radil in the guide that you purchased, and hookk and disconnect the old speakers. This may mean either sliding the existing hlok connections off a connector, or cutting the wires completely. Car radio hook up CCar old wires to Dating rejection after divorce new speaker, connecting the ohok colored wires together - negative to negative and positive to positive.

If you had to clip the old wires, strip about a half inch of insulation back for both wires, twist them together and wrap tightly in electrical tape. Then screw the new speaker back in place. Remove the section of the dash that covers your old car stereo, and take off the existing head unit by removing the screws that hold it in place. Unplug the old head unit from the existing connectors. Attach your new wiring harness to your car's connector, and then attach the other end of the wiring harness to your new stereo. All connections should be clear and easy to connect because the harness is manufactured specifically for your car and for the brand of the new stereo. Connect the other wires that aren't part of the connector, such as the antenna and the speaker wires.

Each channel is a speaker with two wires. Not sure which wire is positive or negative? Touch the wires to the 9 volt battery terminals. You can keep the PSU on. I had to unplug the 12 volt supply to turn the light off, Also I did for mine. RussellJ2 3 years ago Reply 89JeepComanche I had some old car stereo components in my garage this morning and wanted to complete this very same project. I also had an old working PC power supply, so your post is very appealing.

This is a great idea, and I'm sure this could work very well. I may still try to use your idea of the PC power supply. Your vehicle's electrical distribution system is a regulated 12VDC system. The power supply may or may not be capable of the amperage output your stereo will draw. The power supply itself may have a sticker to notify you of the maximum amperage draw. The stereo will most likely have a similar sticker, letting you know the maximum expected amperage draw. In reality, the amperage draw will depend on the speakers used and the listening level.

The amperage can be tested by breaking the line between the stereo and amp on either side but some cheap multimeters will only allow you to read a positive amperage. In addition, your car electrical system is fused to protect from an overcurrent condition from damaging electrical components and starting a fire.



« 11 12 13 14 15 »